Card of the week 176

Code: QT3318

For all stock enquiries relating to this product please enter your email address below:


PCD47 Square Nesting Die

ADD10094 Vehicle Frame

ADPP10016 Paper Pack - Vintage Vehicles

SB10152 3D Decoupage – Planes

Extra thick acetate

A3 White Card

Dark Grey Foundation Card

Brown Foundation Card

Mirror Card


Firstly make your card blank by getting an A3 white piece of card and cut to measure 34 x 17 cm then fold in half.

Cut the square die from PCD47 square nesting die which measures 17 x 17 cm in dark grey foundation card.

Combing two square dies from PCD47 measuring 16.3 x 16.3 cm and 10.6 x 10.6 cut in brown foundation card to make a window frame effect.

Now pick a design from ADPP10016 paper pack vintage vehicles (we used the aeroplane silhouette) place the square die from PCD47 measuring 11.5 x 11.5 centrally onto your design and cut.

Cut ADD10084 vehicle frame die in mirror card.

Cut a strip of extra thick acetate measuring roughly 1 x 15 cm, now stick onto your card blank making sure you have enough to dangle over the front of your card as show in photo.

Now using the layered double wing plane design numbered 1,3, and 4 from SB10152 3D decoupage planes, layer using silicone glue and foam pads centrally onto the dark grey foundation card you cut out earlier. Now stick onto the front of your card blank.

Stick your brown foundation card window cut out on top using foam pads to give it a raised effect. Now stick your paper pack design on top of that followed by your mirror card frame cut out.

Finish off sticking design 2 double wing plane from SB10152 onto the end of your acetate cut out. Bend the acetate cut out until your plane is overhanging on the front of the card giving it the illusion its flying.