Card of the week 299

Code: QT7165

For all stock enquiries relating to this product please enter your email address below:

Materials

ADEMB10008 Vintage Winter Cutting and Embossing Folder

SB10371 Deers in Gold

CAT005 Glitter Touch Metallic

CTGFP-1 Silver Glitter

CTGFP-2 Gold Glitter

Instructions

Cut a piece of white foundation card to measure 29.8 x 14.7 cm then fold in half to make your card blank.

Cut a piece of ivy green card to measure 13.8 x 13.8 cm followed by some glitter silver card (CTGFP-1) to measure 13 x 13 cm

Stick both squares onto your card blank

Using ADEMB10008 vintage winter cutting and embossing folder, cut and emboss in white foundation card then cut into a square which measures 12.3 x 12.3 cm, now using the silver metallic from CAT005 glitter touch, go over all the embossed areas as desired (please note you may need to wait for it to dry before you carry on).

Cut a piece of acetate to measure 12.3 x 12.3cm which will be stuck directly behind your vintage winter cut out.

Cut a strip of silver glitter card to measure roughly 12.2 x 2.5 cm; this will be stuck onto the back of your acetate directly behind the stars cut outs of your embossed picture as shown. Now cut a piece of gold glitter card (CTGFP-2) to roughly measure 5 x 4 cm which will be stuck directly behind the lamp post lights as shown.

Using the first deer design from 3D push out SB10371 deers in gold place each part in numerical order directly in line with the vintage winter circle cut out, best way to do this is lay the deer push outs onto your card blank and place your vintage winter cut out on top until its inline with the circle, then stick with foam pads onto your card blank, now using sticky foam pads stick around edges of the back of your winter cut out as shown.

Dab over your circle acetate window with a white glaze pen over as desired giving it a snowy like appearance.